# 1 "/root/.topspin-BladeEpu/local_acqu/simulDirs/ppDirs/solidecho"
# 1 "<built-in>"
# 1 "<command-line>"
# 1 "/root/.topspin-BladeEpu/local_acqu/simulDirs/ppDirs/solidecho"
;solidecho (TopSpin 2.0)
;
;TS3 / 03.06.2011
;
;checked by SEWE 03.06.2011
;
;
;90-90 solid echo sequence for wide line observation
;
;set d6 to 5-100usec depending on dead time
;set d7 shorter than d6 by 3usec plus 10 dw to make
;sure the evolution of the echo is obvserved, then left shift
;FID prior to ft to get smallest possible 1st order pohase correction
;set receiver phase either with phcor0 or with HPCU receiver phase
;to get maximum signal in ADC channel A and almost no signal in channel B
;for minimum 0 order phase correction (no signal in channel B  is only
;possible if O1 exactly in center and spectrum perfectly symmetric).
;phase cycle will cancel deadtime partially, but not perfectly
;
;
;parameters:
;pl1 : X power level for 90
;p1 : X 90 degree pulse
;d1 : recycle delay
;d6 : echo delay
;d7 : =0, or no longer than d6-de
;ns : = 8*n
;
;
;$CLASS=Solids
;$DIM=1D
;$TYPE=direct excitation
;$SUBTYPE=simple 1D
;$COMMENT=90-90 solid echo sequence for wide line observation

prosol relations=<solids_default>

# 39 "/root/.topspin-BladeEpu/local_acqu/simulDirs/ppDirs/solidecho"
;cnst11 : to adjust t=0 for acquisition, if digmod = baseopt
"acqt0=0"

# 42 "/root/.topspin-BladeEpu/local_acqu/simulDirs/ppDirs/solidecho"
1 ze
2 d1
  (p1 pl1 ph1):f1
  d6
  (p1 ph2):f1
  d7
  go=2 ph31 
  wr #0
exit

ph0=0
ph1= 0 3 2 1 0 3 2 1
ph2= 3 2 1 0 1 0 3 2
ph31= 3 2 1 0 3 2 1 0
# 59 "/root/.topspin-BladeEpu/local_acqu/simulDirs/ppDirs/solidecho"
;$Id: solidecho,v 1.7 2017/02/22 16:58:55 ber Exp $
